Layouts for lower volume house condition

[rf67pccb]

Eric etal....

I bowl on a synthetic 18 mil 39-foot house shot. (current conditioner) I am currently having some success with a Gem drilled at 90X1.75X45 surfaced at 1000. This seems to work the best. I have extensively trialed all surfaces including polish.

The house carry is difficult for everybody in general. There are no 220 averages here, unlike other houses closeby that have 15-20 averages 220+.

Are there possibly layouts with longer pins (asyms) that might give me more hit but with comparable control?

I am open to any ball solid/hybrid/pearl etc.


Thanks

[EricHartwell]

Try 55-5-55 Pin in the middle finger.
An adjusted Control layout for your release specs to provide a straighter line of play.
The adjustment is the longer 5" Pin to PAP to get the ball to transition to roll without hooking the whole lane.

[rf67pccb]

Would the Ebonite Envision be a candidate for that layout?

[EricHartwell]

It is barely Asymmetrical. Intermediate Differential of .010

The drilling of the thumb hole will pull the PSA almost to it.
Post drilled you would end up with a Drilling angle closer to 75*+

If you are set on this ball I would compensate with a smaller Drilling angle. 30-5-55
I would actually consider a different ball.
Maybe something like this...

https://brunswickbowling.com/products/b ... t/defender
or
https://brunswickbowling.com/products/b ... evo-hybrid

With the DOT technology no adjustment to the 55-5-55 will be needed.

[rf67pccb]

Thankyou very much. I will rethink this