i've drilled a ball twice should i drill that ball again
Moderator: Moderators
-
- Member
- Posts: 8
- Joined: August 26th, 2019, 2:05 pm
- THS Average: 210
- Sport Average: 157
- Positive Axis Point: idk
- Speed: 15.5-18.3
- Rev Rate: 480
- Axis Tilt: 7
- Axis Rotation: 50
- Heavy Oil Ball: Piranha powercor
- Medium Oil Ball: Cuda powercor
- Light Oil Ball: vendetta
- Preferred Company: any
i've drilled a ball twice should i drill that ball again
the last time i drilled it was when my ball speed was 15-16 mph my ball speed 16-17 mph and higher tilt and also has thumb hole because i was still one handed at the time i drilled now i'm two handed it was drilled to be more length and smooth backend but now i need more backend with 200 games on it it's now slow to friction
-
- Member
- Posts: 658
- Joined: January 25th, 2017, 3:10 am
- Preferred Company: Radical, Brunswick
- Location: Valrico Florida
Re: i've drilled a ball twice should i drill that ball again
Are you getting it de-oiled and refreshing surface?
Stacy
- EricHartwell
- Trusted Source
- Posts: 4080
- Joined: April 5th, 2011, 12:24 am
- Positive Axis Point: 4-3/4" and 1/2"up
- Speed: 16 off hand
- Rev Rate: 330
- Axis Tilt: 12
- Axis Rotation: 45
- Heavy Oil Ball: Radical Tremendous, EVO solid, Hammer Obsession
- Medium Oil Ball: EVO pearl, True Motion, Columbia Command, DV8 Intimidator
- Light Oil Ball: Blue Hammer
- Location: Michigan
Re: i've drilled a ball twice should i drill that ball again
Do you have access to a DeTerminator to spin it and find out where the PSA is?
Check out this link for the information needed to figure out layouts for you.....
viewtopic.php?f=15&t=373
Check out this link for the information needed to figure out layouts for you.....
viewtopic.php?f=15&t=373
Eric Hartwell
Right Handed
PAP 4.75" up 1/2"
45* rotation
12* tilt
330 rev rate
16 mph off hand
Right Handed
PAP 4.75" up 1/2"
45* rotation
12* tilt
330 rev rate
16 mph off hand
Re: i've drilled a ball twice should i drill that ball again
If you do drill the thumb first, how do you compensate for the finger inserts? I know if you drill the fingers first, you don't really need a cut-to-cut span and just use a full span measurement.
-
- Trusted Source
- Posts: 3174
- Joined: January 18th, 2010, 9:21 pm
Re: i've drilled a ball twice should i drill that ball again
I just measure the inserts and subtract that from the cut to cut measurement.