Board index » General Forums » The Pro Shop




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Turbo switch grip drilling depth
 Posted: Tue Oct 03, 2017 9:53 pm Post Number: #1 Post
Offline
Member

Joined: August 7, 2017
Posts: 81
Location: Lake Geneva WI
Reputation: 0
Reputation Power: 1
I am going to a B attempting to install my first turbo switch grip and was curious to know the actual depth of the drillbit provided by turbo with the auto stopper. The reason I am asking is because I have not yet purchased that drillbit and I am going to attempt to do it with the regular inch and a half. Any help on this subject would be greatly appreciated.

It's for the thumb.

_________________
-Knowledge is power-
PAP-5 1/16 by 3/4 up
Speed-16mph on monitor
Rev-325rpm
Tilt-10*
Rotation-70*-90*


Top 
 Profile  
Reply with quote  
 Post subject: Re: Turbo switch grip drilling depth
 Posted: Wed Oct 04, 2017 5:48 pm Post Number: #2 Post
Offline
Pro Shop

Joined: August 28, 2012
Posts: 299
Location: Dublin, Ireland
Reputation: 63
Reputation Power: 1
Put a mark on the drill bit with a pen or pencil or a scratch to mark the depth. As the bit goes into the ball the mark will reach the surface of the ball and you stop drilling. Place the switch grip next to the bit and you will see where to mark the bit. Marking the bit will not impair the ability to make a hole.

I have also used this method for inserts and slugs.


Top 
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
 
Post new topic Reply to topic  [ 2 posts ] 

Board index » General Forums » The Pro Shop


 
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: