Requesting a Performance Fit

This forum is for topics related to pro shop operation and bowling center maintenance.
Usual topics include: shop gear, fitting, drilling and lane maintenance.

Moderator: Moderators

Post Reply
User avatar
kzues765
Member
Member
Posts: 76
Joined: November 29th, 2011, 1:07 am
THS Average: 212
Sport Average: 196
Positive Axis Point: 4 11/16 left and up 1/2
Speed: 18
Rev Rate: 425
Axis Tilt: 20
Axis Rotation: 55
Heavy Oil Ball: n/a
Location: Warren, OH

Requesting a Performance Fit

Post by kzues765 »

I am looking for a performance fit. I am not happy with where I am at.
Here is my drill sheet.
drill sheet spec kz 111116.gif

Here is my finger bending ability is at 50 to 70 degrees.[img]
middle%20finger%20bend%20gif.gif
[/img]

My ring finger bending ability is less than my middle finger.
[img]
ring%20finger%20bend%20gif.gif
[/img]

I am rubbing on the inside of my ring finger around the lower side of the knuckle.
[img]
both%20finger%20side%20view%20gif.gif
[/img]

I am also dragging on the inside of my thumb if I use a pitch greater than zero on lateral pitch. I have tried an 1/8 away. It does not feel that bad. But right now I think I am comfortable with zero side lateral pitch.

The most comfortable release for me is almost coming out of the ball at 60 degrees. When I am up the back of the ball I do not feel of notice this rubbing. As I start to increase my axis tilt I experience it.

I am also rubbing coming out of the ball on the back side of ring nail. I notice it only when I go across alley at a seven pin or a 4 - 7 combination.
[img]
both%20fingers%20bend%20gif%20file.gif
[/img]
You do not have the required permissions to view the files attached to this post.
Left handed
Ball Speed 17
Average THS: 209
Average on Sport: 193
Rev Rate: 425
Axis Rotation: 55*
Axis Tilt: 20*
PAP: 4 11/16 left up 1/2"
Post Reply