deep cuts due to ball return

Bowling ball related topics including new products, arsenals and comparisons.

Moderator: Moderators

Post Reply
Posts: 1155
Joined: March 18th, 2016, 12:43 am
Preferred Company: hammer

deep cuts due to ball return

Post by krava » October 23rd, 2018, 7:59 am

ball returns have been failing all over the place where I am. If you take my ball place it infront of you with the fingers and the thumb hole, I have a 1.5" by 2-4mm wide cut on the ball to the north east side of the ball about 3 inches from the fingers. It isn't in the track area. Will that cut effect anything on the ball or time to let the ball go. That ball is my favorite ball out of all. Radical ridiculous. it is a bench mark ball with more backend then say a storm rocketship.

i have a game breaker 3 that could maybe fill that void I haven't used but thumb hole is too large and needs to get fixed but not sure if the backend can match the ridiculous.

dv8 poision coming out is simular config but it is asymmetric.

Trusted Source
Trusted Source
Posts: 3432
Joined: January 31st, 2010, 1:04 am
Positive Axis Point: 15 15/16 x 3/16
Speed: 13.5 (Qubica)
Axis Tilt: 13
Axis Rotation: 45
Location: Hawesville KY/Tell City IN

Re: deep cuts due to ball return

Post by JohnP » October 23rd, 2018, 4:41 pm

It won't affect the ball's motion, just its appearance. A good pro shop will be able to repair it so you won't hardly be able to tell where it was. -- JohnP

Post Reply