Page 1 of 1

Layout recommendations

Posted: February 10th, 2018, 8:35 pm
by TMack
Looking for layouts for me:
THS med/heavy oil
Pro Anvil lanes
Right handed
4 3/4 x 3/4 up
Tilt 17'
Axis Rotation 65'
Speed off hand 17.5 mph
Rev rate 320


Thanks in advance!!

Re: Layout recommendations

Posted: February 11th, 2018, 4:03 am
by EricHartwell
TMack wrote:Looking for layouts for me:
THS med/heavy oil
Pro Anvil lanes
Right handed
4 3/4 x 3/4 up
Tilt 17'
Axis Rotation 65'
Speed off hand 17.5 mph
Rev rate 320


Thanks in advance!!
Sweetspot 90* Totals, 1:1 Ratio

Asymmetrical layouts
Totally Strong ................ 45-5-25
Midlane ......................... 25-4.5-45
Benchmark .................... 45-4-45
Long and Strong ............. 65-4-45
Control .......................... 45-3.5-65
low flare ........................ 65-2.5-45

Symmetrical layouts (Drilling Angle measured to Cg)
Totally Strong ................. Double Thumb layout
Benchmark .................... 60-4-40 balance hole 1.5" below midline on the VAL
Long and Strong ............. 75-4-40
Control .......................... 65-4.25-60 pin in Ring finger, bal hole 1.5" below midline on the VAL
low flare ........................ 75-5-40

Re: Layout recommendations

Posted: February 12th, 2018, 12:16 am
by TMack
Thanks Eric!!