Tech Talk: What to do when oil doesn't set before league!
Posted: November 8th, 2019, 6:21 pm
Okay this should be good for a discussion.
TL;DW version (If I'm following him.)
1-They get done oiling 5 mins. before you start bowling. But the oil needs 15-30 mins to properly stick to the lane.
2-A lot of people start bowling with plastic and Urethane balls and pumping it down second arrow, they make a lot of carrydown in front of the head pin and everyone one starts leaving 10 pins.
What do you do?
If your a low rev stroker tweener, You buy or use a "Strong" Solid or Hybrid Asym., Drilled up strong (Example given: 65° x 4.5" x 30°) with a lot surface.
Other options:
1- move right (or left as the case maybe)
2-If your ball is fast, slow it down.
3-Come up the back of the ball, make it read earlier.
This is called shaping the shot.
[youtube][/youtube]
TL;DW version (If I'm following him.)
1-They get done oiling 5 mins. before you start bowling. But the oil needs 15-30 mins to properly stick to the lane.
2-A lot of people start bowling with plastic and Urethane balls and pumping it down second arrow, they make a lot of carrydown in front of the head pin and everyone one starts leaving 10 pins.
What do you do?
If your a low rev stroker tweener, You buy or use a "Strong" Solid or Hybrid Asym., Drilled up strong (Example given: 65° x 4.5" x 30°) with a lot surface.
Other options:
1- move right (or left as the case maybe)
2-If your ball is fast, slow it down.
3-Come up the back of the ball, make it read earlier.
This is called shaping the shot.
[youtube][/youtube]