Board index » General Forums » General Bowling




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: Ebonite Ultra fit tool with 5/8 blade
 Posted: Tue Jun 25, 2019 12:43 am Post Number: #1 Post
Offline
Member

Joined: March 6, 2015
Posts: 176
Reputation: 3
Reputation Power: 1
Folks,
Looking into purchasing one to clean out and minamly enlarge some thumb holes. Has anybody ever used this tool and does it get the job done. Thanks in advance for your comments and advice. I never seem to get it right using sandpaper.

_________________
Joel Resnick
Hand: Left
PAP: 4 11/16 over 1 up
Speed: 13 off hand
Rev Rate: 200
Axis Tilt: 24
Axis Rotation: 75

No matter what you are trying to do remember simplicity gives better results than over complicating things.


Top 
 Profile  
Reply with quote  
 Post subject: Re: Ebonite Ultra fit tool with 5/8 blade
 Posted: Wed Jun 26, 2019 8:00 pm Post Number: #2 Post
Offline
Member

Joined: October 18, 2011
Posts: 155
Reputation: 18
Reputation Power: 1
It's good for minimal scrapping for slightly enlarging the hole where material needs to be removed. I used mine more for cleaning up sanding scratches. since I used a 5/8 sanding drum, both on a drill and on a screwdriver handle, while finish grooming the sides of my thumb holes. Trying to take too much material out of an insert (or ball) could gouge out a divot.


Top 
 Profile  
Reply with quote  
 Post subject: Re: Ebonite Ultra fit tool with 5/8 blade
 Posted: Wed Jun 26, 2019 11:51 pm Post Number: #3 Post
Offline
Member

Joined: March 6, 2015
Posts: 176
Reputation: 3
Reputation Power: 1
georgeh wrote:
It's good for minimal scrapping for slightly enlarging the hole where material needs to be removed. I used mine more for cleaning up sanding scratches. since I used a 5/8 sanding drum, both on a drill and on a screwdriver handle, while finish grooming the sides of my thumb holes. Trying to take too much material out of an insert (or ball) could gouge out a divot.

George,

Thanks for your reply and I ordered the tool and will heed your advice about trying not to take too much out. Hopefully it will work to clean and remove very little from the thumb hole.

_________________
Joel Resnick
Hand: Left
PAP: 4 11/16 over 1 up
Speed: 13 off hand
Rev Rate: 200
Axis Tilt: 24
Axis Rotation: 75

No matter what you are trying to do remember simplicity gives better results than over complicating things.


Top 
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
 
Post new topic Reply to topic  [ 3 posts ] 

Board index » General Forums » General Bowling


 
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: