Static Weight Question
Moderator: Moderators
-
- Pro Shop
- Posts: 42
- Joined: February 3rd, 2010, 3:49 pm
- Preferred Company: Ebolumiba
Static Weight Question
if i was to get a ball with a 4-5 pin that had 5 oz of top, and used a double thumb layout, is it possible to get the thumb/side weight out of it? Or should i skip this ball and try and get one with less top. Its an x-out so its pretty cheap.
- Mo Pinel
- Rest In Peace
- Posts: 10054
- Joined: January 26th, 2010, 6:10 pm
- Preferred Company: MoRich, & now RADICAL BT
- Location: Richmond, VA
Re: Static Weight Question
It will work well if you drill the fingers 3 1/2" deep and use a 1 3/8" thumb slug or, even better, an interchangeable thumb. You'll be able to use a big balance hole, which will make the reaction really strong.the bowlers edge wrote:if i was to get a ball with a 4-5 pin that had 5 oz of top, and used a double thumb layout, is it possible to get the thumb/side weight out of it? Or should i skip this ball and try and get one with less top. Its an x-out so its pretty cheap.
Rest In Peace (1942-2021)
-
- Pro Shop
- Posts: 42
- Joined: February 3rd, 2010, 3:49 pm
- Preferred Company: Ebolumiba
Re: Static Weight Question
i use a 1 1/4 vise thumb mold. but i was just making sure i could get enough weight out of it. thanks mo! i'll go get it.