rev dominate
Moderator: Moderators
rev dominate
Im bowling with two hands and im wondering what would be the best layouts for medium light conditions? I am on the extreme side of rev dominanance my ball speed on the monitors read 15.5 but my rev rate is about 460. I know i have alot of tilt also just not sure how much.
- kellytehuna
- Senior Member
- Posts: 2891
- Joined: January 18th, 2010, 11:11 pm
- THS Average: 195
- Positive Axis Point: 3.75", 1" up
- Speed: 18
- Rev Rate: 480
- Axis Tilt: 17
- Axis Rotation: 40
- Heavy Oil Ball: Morich DestroyR
- Medium Oil Ball: Morich Perpetual Motion
- Light Oil Ball: Morich Mojave
- Preferred Company: Morich
- Location: Hazard, KY
Re: rev dominate
If you can find your tilt that would be helpful to getting the process started. If you could give an indication of your starting rotation as well, that would complete the info we need.
Father, Husband, Bowler, Web developer
15lb Morich DestroyR, Mania, Perpetual Motion, Craze, Frenzy, Mojave
15lb Radical Yeti
15lb Brunswick Slingshot, Avalanche Urethane
Highest score: 279
Highest series: 818
15lb Morich DestroyR, Mania, Perpetual Motion, Craze, Frenzy, Mojave
15lb Radical Yeti
15lb Brunswick Slingshot, Avalanche Urethane
Highest score: 279
Highest series: 818
Re: rev dominate
Ok ill give this a try,i know my axis rotation is a little higher than 45 degrees but not close to 90 so my guess would be about 65 degrees. Now the tilt im still not too sure but i figure it must be alot because of my cocked hand at release.
- kellytehuna
- Senior Member
- Posts: 2891
- Joined: January 18th, 2010, 11:11 pm
- THS Average: 195
- Positive Axis Point: 3.75", 1" up
- Speed: 18
- Rev Rate: 480
- Axis Tilt: 17
- Axis Rotation: 40
- Heavy Oil Ball: Morich DestroyR
- Medium Oil Ball: Morich Perpetual Motion
- Light Oil Ball: Morich Mojave
- Preferred Company: Morich
- Location: Hazard, KY
Re: rev dominate
If you can, next time you bowl, trace the FIRST oil ring with a grease pencil, or some other non-permanent marking writing device. Then measure the distance across the diameter. Once you have that measurement, for every 1/2" less than 13 1/2", add 3.5° of tilt.
Hope that helps. No need to rush and get this stuff. Take your time. We'll still be here
Hope that helps. No need to rush and get this stuff. Take your time. We'll still be here
Father, Husband, Bowler, Web developer
15lb Morich DestroyR, Mania, Perpetual Motion, Craze, Frenzy, Mojave
15lb Radical Yeti
15lb Brunswick Slingshot, Avalanche Urethane
Highest score: 279
Highest series: 818
15lb Morich DestroyR, Mania, Perpetual Motion, Craze, Frenzy, Mojave
15lb Radical Yeti
15lb Brunswick Slingshot, Avalanche Urethane
Highest score: 279
Highest series: 818