Page 1 of 1

Hammer Statement Hybrid (overseas) X-Out

Posted: December 11th, 2019, 6:32 pm
by Progmtl
I got a pretty good deal on the above ball. I have a question for those in the know about the X-Out part of this (has to do with measurements).

The ball is a 14.14 with 3 ounces of TW (listed on box). Pin to CG is 2.5", and Pin to MB is 5" (per the markings & all are in a straight line). When drilling this what markings should be held and which one do you think is probably mislabeled?

Thanks for any input.

Re: Hammer Statement Hybrid (overseas) X-Out

Posted: December 11th, 2019, 6:37 pm
by 44boyd
Who knows without x-ray. Could be irregular top weight, pin or surface blemish.

Re: Hammer Statement Hybrid (overseas) X-Out

Posted: December 11th, 2019, 6:40 pm
by Progmtl
The Pin to MB distance is 1-3/4" short from standard. Am hoping that is might just be the MB is marked incorrectly.

Re: Hammer Statement Hybrid (overseas) X-Out

Posted: December 11th, 2019, 6:50 pm
by 44boyd
Unfortunately that’s the most important mark you need

Re: Hammer Statement Hybrid (overseas) X-Out

Posted: December 15th, 2019, 4:30 pm
by EricHartwell
X-outs are a crap shoot, you never really know what your going to get.

The Pin is the only indicator that can be trusted.

Spin it on a DeTerminator to figure out where the Mass Bias is located.
Verify the the CG and Top weight with a scale.