i've drilled a ball twice should i drill that ball again

Which layout is right for me?

Moderator: Moderators

Post Reply
andrewstack23
Member
Member
Posts: 8
Joined: August 26th, 2019, 2:05 pm
THS Average: 210
Sport Average: 157
Positive Axis Point: idk
Speed: 15.5-18.3
Rev Rate: 480
Axis Tilt: 7
Axis Rotation: 50
Heavy Oil Ball: Piranha powercor
Medium Oil Ball: Cuda powercor
Light Oil Ball: vendetta
Preferred Company: any

i've drilled a ball twice should i drill that ball again

Post by andrewstack23 »

the last time i drilled it was when my ball speed was 15-16 mph my ball speed 16-17 mph and higher tilt and also has thumb hole because i was still one handed at the time i drilled now i'm two handed it was drilled to be more length and smooth backend but now i need more backend with 200 games on it it's now slow to friction
44boyd
Member
Member
Posts: 658
Joined: January 25th, 2017, 3:10 am
Preferred Company: Radical, Brunswick
Location: Valrico Florida

Re: i've drilled a ball twice should i drill that ball again

Post by 44boyd »

Are you getting it de-oiled and refreshing surface?
Stacy
User avatar
EricHartwell
Trusted Source
Trusted Source
Posts: 4080
Joined: April 5th, 2011, 12:24 am
Positive Axis Point: 4-3/4" and 1/2"up
Speed: 16 off hand
Rev Rate: 330
Axis Tilt: 12
Axis Rotation: 45
Heavy Oil Ball: Radical Tremendous, EVO solid, Hammer Obsession
Medium Oil Ball: EVO pearl, True Motion, Columbia Command, DV8 Intimidator
Light Oil Ball: Blue Hammer
Location: Michigan

Re: i've drilled a ball twice should i drill that ball again

Post by EricHartwell »

Do you have access to a DeTerminator to spin it and find out where the PSA is?

Check out this link for the information needed to figure out layouts for you.....

viewtopic.php?f=15&t=373
Eric Hartwell

Right Handed
PAP 4.75" up 1/2"
45* rotation
12* tilt
330 rev rate
16 mph off hand
User avatar
KurtHuhn
Member
Member
Posts: 4
Joined: December 24th, 2019, 6:06 am

Re: i've drilled a ball twice should i drill that ball again

Post by KurtHuhn »

If you do drill the thumb first, how do you compensate for the finger inserts? I know if you drill the fingers first, you don't really need a cut-to-cut span and just use a full span measurement.
elgavachon
Trusted Source
Trusted Source
Posts: 3174
Joined: January 18th, 2010, 9:21 pm

Re: i've drilled a ball twice should i drill that ball again

Post by elgavachon »

KurtHuhn wrote: December 24th, 2019, 8:46 pm If you do drill the thumb first, how do you compensate for the finger inserts? I know if you drill the fingers first, you don't really need a cut-to-cut span and just use a full span measurement.
I just measure the inserts and subtract that from the cut to cut measurement.
Post Reply