BowlingChat.net
http://forum.bowlingchat.net/

4 right 2 up PAP
http://forum.bowlingchat.net/viewtopic.php?f=15&t=13805
Page 1 of 1

Author:  Spartacus [ Sat May 12, 2018 11:56 pm ]
Post subject:  4 right 2 up PAP

Hi, my friend has a very low track and I am asking a general question: medium revs, and a lot of spin (not UFO but ~1/3 of the way there) Should I treat his PAP like a typical reference point to layout or is there something totally different (dare I ask about Rico?!) fora low,low track with an added dose of spin?

Looking at his balls they are all 1-3" length Pins. He said no one ever looked at his PAP to drill . They were drilled all about the same, pin over ring and CG slightly to the right of the thumb.
He has a Code Red that he threw a 300 with this year that is the most "normal" looking for his PAP, it measures 50 x 3" x 35.

Author:  EricHartwell [ Tue May 22, 2018 12:22 am ]
Post subject:  Re: 4 right 2 up PAP

Spartacus wrote:
Hi, my friend has a very low track and I am asking a general question: medium revs, and a lot of spin (not UFO but ~1/3 of the way there) Should I treat his PAP like a typical reference point to layout or is there something totally different (dare I ask about Rico?!) fora low,low track with an added dose of spin?

Looking at his balls they are all 1-3" length Pins. He said no one ever looked at his PAP to drill . They were drilled all about the same, pin over ring and CG slightly to the right of the thumb.
He has a Code Red that he threw a 300 with this year that is the most "normal" looking for his PAP, it measures 50 x 3" x 35.

Utilize his PAP 4" over and 2" up as the typical reference point.

As for Rico, with a PAP measurement of 4" over and 2" up, it would measure out to 80-4 3/8-110
Not a Dual Angle layout I would recommend for anyone.

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/