Page 1 of 1

4 right 2 up PAP

Posted: May 12th, 2018, 11:56 pm
by Spartacus
Hi, my friend has a very low track and I am asking a general question: medium revs, and a lot of spin (not UFO but ~1/3 of the way there) Should I treat his PAP like a typical reference point to layout or is there something totally different (dare I ask about Rico?!) fora low,low track with an added dose of spin?

Looking at his balls they are all 1-3" length Pins. He said no one ever looked at his PAP to drill . They were drilled all about the same, pin over ring and CG slightly to the right of the thumb.
He has a Code Red that he threw a 300 with this year that is the most "normal" looking for his PAP, it measures 50 x 3" x 35.

Re: 4 right 2 up PAP

Posted: May 22nd, 2018, 12:22 am
by EricHartwell
Spartacus wrote:Hi, my friend has a very low track and I am asking a general question: medium revs, and a lot of spin (not UFO but ~1/3 of the way there) Should I treat his PAP like a typical reference point to layout or is there something totally different (dare I ask about Rico?!) fora low,low track with an added dose of spin?

Looking at his balls they are all 1-3" length Pins. He said no one ever looked at his PAP to drill . They were drilled all about the same, pin over ring and CG slightly to the right of the thumb.
He has a Code Red that he threw a 300 with this year that is the most "normal" looking for his PAP, it measures 50 x 3" x 35.
Utilize his PAP 4" over and 2" up as the typical reference point.

As for Rico, with a PAP measurement of 4" over and 2" up, it would measure out to 80-4 3/8-110
Not a Dual Angle layout I would recommend for anyone.