Page 1 of 1

Layout Help Needed

Posted: April 6th, 2018, 1:11 pm
by DustinD
I recently used the Bowlers ID and got updated delivery stats. Im unsure how accurate it really is but i attached the results. My old PAP was 5" and 1-1/8" up and when measured before, rev rate was in 320s, tilt was 14 and rotation was 62.

Could I have my long and strong, becnchmark, control, strong and low falre drillings for my new stats?

Thanks,

Dustin

Re: Layout Help Needed

Posted: April 6th, 2018, 4:21 pm
by EricHartwell
It is going to be a couple of days before I can get to your request.
Posting a reply so it
will be in my post list when I get back to my computer.

Re: Layout Help Needed

Posted: April 9th, 2018, 11:49 am
by DustinD
bump

Re: Layout Help Needed

Posted: April 9th, 2018, 10:15 pm
by EricHartwell
First thing I would do Is verify your PAP on a ball that has significant amount of flare. I am assuming the Bowler ID was not with your own ball, it was on a ball that did not flare, is that correct?

You are slightly speed dominant with higher rotation.
Sweetspot 90* Totals, 1.25:1 Ratio

Asymmetrical Layouts
Totally Strong ............. 55-4.5-55
Midlane ..................... 30-4.5-40
Benchmark ................ 50-4.25-40
Long and Strong ......... 70-4.25-40
Control ...................... 50-3.75-60
low flare .................... 70-2.25-40

Symmetrical Layouts (drilling angle to the Cg)
Totally Strong ............. Double Thumb layout
Midlane ..................... 55-4-35 balance hole 1.5" below midline on the VAL
Benchmark ................ 55-4-35 P3
Long and Strong ......... 75-4.25-35
Control ...................... 65-4.25-55 balance hole 2" below midline on the VAL
low flare .................... 70-5-35

Re: Layout Help Needed

Posted: April 9th, 2018, 10:19 pm
by DustinD
Yes bowlers ID is on non flaring urethane ball that doesn't have my pitches or span

Re: Layout Help Needed

Posted: April 9th, 2018, 11:12 pm
by EricHartwell
I would definitely mark out your old PAP you had mentioned on a flaring ball and see how accurate that is, adjust as necessary before drilling anything up.

Re: Layout Help Needed

Posted: April 10th, 2018, 3:38 pm
by DustinD
Measured pap on high flare ball last night, my old PAP is correct. 5" over, 1-1/8" up.

Re: Layout Help Needed

Posted: April 10th, 2018, 7:22 pm
by snick
I'm concerned that your axis tilt may different with your grip specs than listed from bowlerID.
Using an Armadillo to measure your PAP, what is the distance from your PAP to the first oil ring (closest to the gripline)? Armadillo has embossed lines on the surface in inches for finding this value.