Layout Advice for Long/Heavy Patterns

Which layout is right for me?

Moderator: Moderators

smcintire
Member
Member
Posts: 6
Joined: January 22nd, 2018, 4:50 pm
Preferred Company: 900 Global

Re: Layout Advice for Long/Heavy Patterns

Post by smcintire »

EricHartwell wrote:Sweetspot totals 105*, 1.75:1 Ratio

Asymmetrical Layouts ...
Totally Strong .............. 50-4.5-35
Midlane ...................... 45-4.5-40
Benchmark ................. 65-3.75-40
Long and Strong ......... 85-3.75-40
Control ...................... 65-3.25-60
low flare .................... 85-2.25-40

Symmetrical Layouts (drilling angle to Cg)...
Totally Strong .............. Double Thumb layout
Midlane ...................... 50-4-35 bal hole 1.5" below midline on the VAL
Benchmark ................. 70-4.5-35
Long and Strong ......... 90-4.5-35 option for Motion Hole
Control ...................... 65-4.75-55 adj. to pin in ring finger
low flare .................... 85-5.25-35
Thank you for all the help. I'll def give a few of these (or all of them) a try! Thanks again
Post Reply