Page 1 of 1

Morich Awesome Revs 16lbs layout

Posted: September 12th, 2017, 1:54 pm
by jannepalo
Hi! I got my hands on a Morich Awesome Revs 16lbs ball with no existing holes on it.
One of my customers would like have it drilled. The problem is that the ball has 1" pin and 3,4oz topweight. Customers specs are:
PAP: 5-1/16 over 1 up
Speed: 16,5 - 17 mph off hand
Revs: 275 - 300 rpm
Tilt: 20dg
Rotation: 80dg

I would like to have 30dg val buth seems impossible. Im thinking 45/5/60 pin bethween and below fingers and maybe add some surface..

Re: Morich Awesome Revs 16lbs layout

Posted: September 12th, 2017, 3:52 pm
by JohnP
Check the cg location on your dodo scale before proceeding. -- JohnP

Re: Morich Awesome Revs 16lbs layout

Posted: September 12th, 2017, 4:21 pm
by EricHartwell
jannepalo wrote:Hi! I got my hands on a Morich Awesome Revs 16lbs ball with no existing holes on it.
One of my customers would like have it drilled. The problem is that the ball has 1" pin and 3,4oz topweight. Customers specs are:
PAP: 5-1/16 over 1 up
Speed: 16,5 - 17 mph off hand
Revs: 275 - 300 rpm
Tilt: 20dg
Rotation: 80dg

I would like to have 30dg val buth seems impossible. Im thinking 45/5/60 pin bethween and below fingers and maybe add some surface..
45-5-60 is a Control layout for this bowler. It should work well

Re: Morich Awesome Revs 16lbs layout

Posted: September 12th, 2017, 4:23 pm
by jannepalo
I scaled the pin-cg to be 1,5"