Since there seems to be a lot af bowling-center staff and owners on this site it would be great with a forum for pinsettermachines Ever center-owner has his tips and tricks when it comes to machines. It would be great to be able to share this with eachother.
Anyway... great ( and addictive )site! Keep up the good work!
Machine-maintenance forum
Moderator: Moderators
- Jonny Sweden
- Pro Shop
- Posts: 71
- Joined: October 7th, 2010, 8:39 pm
- THS Average: 207
- Positive Axis Point: 5 1/2 over and 9/16 up
- Rev Rate: 273
- Axis Tilt: 10*
- Axis Rotation: 35
- Heavy Oil Ball: Rumble
- Medium Oil Ball: wrecker
- Preferred Company: Morich
- Location: Sweden
Machine-maintenance forum
http://www.olofstromsbowlinghall.se/
- MegaMav
- Moderator
- Posts: 4694
- Joined: April 27th, 2007, 5:00 am
- THS Average: 225
- Sport Average: 200
- Positive Axis Point: 5.5 Over & 1 Up
- Speed: 16.0 MPH - Camera
- Rev Rate: 375
- Axis Tilt: 14
- Axis Rotation: 45
- Heavy Oil Ball: Radical - Informer
- Medium Oil Ball: Brunswick - Fearless
- Light Oil Ball: Radical - Bonus Pearl
- Preferred Company: Radical Bowling Technologies
- Location: Malta, NY
Re: Machine-maintenance forum
I havent seen enough topics on this to warrant its own forum.Jonny Sweden wrote:Since there seems to be a lot af bowling-center staff and owners on this site it would be great with a forum for pinsettermachines Ever center-owner has his tips and tricks when it comes to machines. It would be great to be able to share this with eachother.
Anyway... great ( and addictive )site! Keep up the good work!
Unless people arent posting these questions because there isnt a forum for it? That usually doesnt stop people though.
If there were pinsetter questions, I would think they would pop up in the pro shop forum, since its focus is on lane and bowling center maintenance as well.
I will keep an eye on topics going forward and see if there is a fit.
If there are tips on this type of stuff, I would recommend the experts start some wiki articles and how-to's on individual machines, that would be most helpful.
Thanks for your suggestion,
-Eric
- russelldean
- BCU Graduate Layouts
- Posts: 877
- Joined: February 14th, 2011, 6:09 am
- THS Average: 230
- Positive Axis Point: 5 up 1/4
- Speed: 20
- Rev Rate: 400
- Axis Tilt: 15
- Axis Rotation: 60
- Preferred Company: Brunswick
- Location: pasco wa
Re: Machine-maintenance forum
Johnny,
There can never be too many places where good information is shared. If you don't find what you need here, Bowltech is a great place to start.
There can never be too many places where good information is shared. If you don't find what you need here, Bowltech is a great place to start.
Please click the Green Button, If i have been helpful..